PWR-01 Series
よくあるご質問 閲覧ランキング
- 耐電圧(耐圧)試験って何ですか?
- 直流電源を接続する配電盤のブレーカ選定について教えてください。
- 検査票、試験成績書、校正証明書、トレーサビリティ証明書について教えてください。
- 電波法の高周波利用設備に該当する製品はありますか。
- VISAライブラリについて教えてください。
- ウォームアップ時間はどれくらいですか。
- 製品に電安法適用表示(PSEマーク)がありません。違法ではないですか。
- 耐電圧試験器を操作するために、必要な資格はありますか。
- PWR-01シリーズのPOWER スイッチをオンにしても動作しません。どうしたら良いでしょうか。
- 製品におけるPCB含有の有無について教えてください。
- マニュアル通りにコマンドを送っているのですが動作しません。どうしたらよいでしょうか。
- Can PWR-01 series absorb regenerative power from a DC brushless motor?
- What are the output voltage and current monitor outputs of PWR-01 series?
- How do I set a fixed IP address for LAN communication on PWR-01 series?
- What is the port number of the LAN socket for communication with PWR-01 series?
- What is the control command compatibility between PWR-01 series and PIA4830 (power supply controller)?
- Are the commands for PWR-01 series disclosed or public?
- Can PWR-01 series be controlled via a USB interface?
- How do I use the output shutdown control for PWR-01 series?
- Can PWR-01 series output an alarm signal at shutdown?
- Do I need to use KI-VISA when controlling PWR-01 series via a LAN interface?
- What is the voltage displayed on the panel when I press the OVP/OCP key twice on PWR-01 series?
- Does PWR-01 series have a function to turn off the output if an excess current flows during operation?
- Can PWR-01 series be used as a negative voltage power supply?
- Can multiple PWR-01 series units be controlled via an RS232C interface?
- Should the configuration of the power-up output state setting be applied only to the master unit in parallel operation of PWR-01 series?
- How do I set up PWR-01 series to turn on the output when the POWER switch is turned on?
- Can PWR-01 series automatically restart the output in the event of a short interruption?
- Can the output of PWR-01 series be controlled by external resistor(s)?
- How do I set the soft start for the output voltage in PWR-01 series?
- How do I set the minimum setting resolution for the PWR-01 series output?
- How do I set the soft start for the output current in PWR-01 series?
- Can Wavy for PWR-01 be used with LAN, USB, or RS232C communication interfaces?
- Can multiple PWR-01 series units be synchronized to output the sequence waveforms?
- Does PWR-01 series have CE marking?
- Has PWR-01 series obtain UL or CSA certification?





